Designer Luxury

How to measure for a belt

The hole you fasten every day tells you more about fit than the number on your jeans. Start with a belt you like, or use a tape measure and the trousers you plan to wear.

Jump to the belt size chart

Measure a belt you own

  1. Fasten your belt as usual and note which hole you use. Then unbuckle it and lay it flat.
  2. Check the new belt’s sizing guide for its starting point. If it shows the leather fold at the buckle, place zero there. If it shows the buckle pin, start at the pin.
  3. Measure straight along the strap to the center of your usual hole. Compare that distance with the new belt’s listed center-hole measurement or adjustment range.

Measure through your belt loops

Put on the trousers you’ll wear with the belt. Run a soft tape through the loops, keep it flat, and pull it as snug as you’d wear the belt. Read the measurement where the tape meets. If you only have string, mark where the ends meet and measure that length against a ruler.

Choose between two sizes

If you measure 92 cm, check the usable hole range for both the 90 cm and 95 cm options. Choose the one that puts 92 cm closest to a middle hole so you have room to adjust either way.

What does 30 mm mean? It’s the strap width. Check that a 3 cm wide strap fits through your belt loops, then use your length measurement to choose the size.

Belt size chart

Use this to convert your measured length. Brand size labels and buckle measuring points can vary.

CentimetersInches
7529.5
8031.5
8533.5
9035.4
9537.4
10039.4
10541.3
11043.3
11545.3
12047.2
12549.2

Inches rounded to the nearest tenth. For example, a 90 cm measurement is about 35.4 inches.